11_Controlling the Filter with an Envelope_1

Introduction to SynthesizersPublished 2012.07.19Updated 2026.07.17
Read article ↓

In DTM, the filter envelope is an important technique for changing a synthesizer's tone over time. This article explains the two basic settings, the Cutoff parameter and the envelope (Amount), and shows how adjusting them lets you create a wide variety of tonal changes, such as a sound opening up gradually from silence or, conversely, becoming more muffled. A strong Envelope value creates dramatic changes and a weak one creates subtle shifts in nuance, greatly expanding the expressiveness of your sound design.

Changing the Tone Over Time

By gradually changing the value of the filter, which shapes the tone, with an envelope,
you can give a sound many different expressions.

Without filter envelope

With filter envelope

It's a synthesizer sound you hear often, isn't it?

We explain filters here
, and envelopes here.

The envelope article changes the volume,
but you can think of it in exactly the same way, applied to the filter value instead.


How to Set the Filter Envelope

  • 1_Cutoff is where the tonal change starts
  • 2_Envelope is the size of the movement

These two points come first.

"Envelope" is also called "Amount" and sets how strongly it works.
Note that at 0 in the center it has no effect and the tone does not change.

Starting from 0 in the center:

raising it toward "+" (right) moves the cutoff to the right,
and lowering it toward "-" (left) moves the cutoff to the left.

For more dramatic tonal changes, turn it further to the left or right.

Example 1-1

↑ With Envelope at maximum on the plus side and Cutoff at its lowest,
the tone gradually opens up from silence.

↑ With Envelope at maximum on the minus side and Cutoff at its highest,
the tone gradually becomes muffled.

If you want less tonal change and just a subtle shift in nuance,
simply weaken the Envelope value.

Next time, we will explain the speed of the tonal change and how it is held.


Frequently asked questions

Q1. What is the difference between the filter envelope and the amp (volume) ADSR envelope?

The amp ADSR envelope controls how the volume changes over time, while the filter envelope controls how the tone (cutoff frequency) changes over time. Both change the sound over time, but their targets differ.

Q2. What happens if I set the Envelope value to 0?

With Envelope at 0, the filter envelope has no effect and the tone does not change. The cutoff value stays fixed.

Q3. How do I create subtle tonal changes?

Setting the Envelope value small (close to 0 in the center) gives you subtle, nuanced tonal changes rather than dramatic ones.